FOUTZ RELEASES NEW BUMP STOP KITS FOR BRONCO RAPTOR

April 23, 2024

If you're looking to upgrade the stock suspension in the front & rear on your Bronco Raptor - Foutz Motorsports has got you covered with these two new bump stop kits.

FRONT LIMIT STRAP & BUMP STOP KIT

Bronco Raptor Front Limit Strap and Bump Stop kit for Stock Lower Arm

KEY FEATURES & BENEFITS

• Designed to work with your factory stock lower a-arm and bolt on to the cast aluminum.

• Limits the top out travel and saves your top shock mount from premature damage.

• Extends the life of your Raptors front suspension components

• Restraints the top out so you don't have to rely on just the shock to stop the droop.

• Engineered to work with Fox, King, or ADS front bump stops. 2.5" OD and 2.5" travel bump stop provides full bottom out protection.

• Works for 2022, 2023 & 2024 Bronco Raptor

EXTREME DURABILITY & STRENGTH

• The 12" straps are made of high quality material that is capable to withstand abuse when you off-road. Their extreme durability will provide you with long lasting strength, unlike cheap straps that will stretch and wear out over time.

• Each strap features 4 layers of military grade webbing with steel mounting tabs at the end that are plated black.

MOUNTING BRACKET WITH BUILT-IN BUMP PAD

• A bump stop pad is built into the mounting brackets as an easy addition for a front bump stop kit to be added at any time.

• The mounting brackets that secure around the front of the lower stock control arm and are mig welded in house and then finished in a hammer black powder coat for ultimate durability and strength.

SEE PRICING & DETAILS FOR THIS PRODUCT

*** INSTALLATION NOTE ***

This kit requires you to weld the Bump stop mount to the frame and should be installed by a qualified welder/fabricator

REAR HYDRAULIC BUMP STOP KIT

This will improve your ride in rough terrain by soaking up the big bumps with ease, while providing you protection from that "accidental" hit you didn't anticipate. Our kit was fully designed in CAD and developed with strength and quality in mind so you're able to get the best geometry possible within the packaging constraints.

It uses a full size 2.5" diameter bump stop with 2.5 of travel to provide the best possible ride quality. Use your choice of full size 2.5" diameter Fox, King, or ADS bump stops. The kit is MIG welded, powder coated in texture black, and bolts on to the factory frame over the stock bump stop area with no frame modifications. Completely bolt on kit on the frame side.

Axle pads also bolt on to the rear axle and are located by the existing spring mounts on both sides and require no welding. You will have to remove a couple of small brackets that are factory welded to the rear axle for wire management however.